CYBEX LCX-425T Wartungshandbuch PDF herunterladen (Seite 34)

Cybex 425T Treadmill Service Manual

Pause/Stop Press once to exit Test Mode.

Time Displays the setup constants, each of which may be modified by pressing the

Up and Down arrows. Each depression of Time cycles to the next parameter.

The Enter key must be pressed to save a changed value. See Setting Operation

Options in chapter 5 of the Owner’s Manual for details.

Up Arrow Increases display constants, see Time.

Down Arrow Decreases display constants, see Time.

Enter Required to save setup values. When pressed display reads “UPdt”.

Pause/End Exit the diagnostic mode and return to Dormant.

Error Codes

Error codes notify you of a problem condition and are displayed on the console. These codes

can also help to indicate the part of the treadmill most likely to be causing the problem. Errors

that present a hazard to the user provide a measure of safety by causing a one second beep,

stopping the treadmill and locking out operation of the treadmill. Reset power by unplugging

unit for a few seconds, then plug power cord into outlet.

A log of errors can be viewed and cleared. Enter Test Mode and press the Pace (min/mi/km)

key to display the log. The most recent error is always first in the log. Press the Pace key

again to cycle to the next the error stored. Up to 10 errors can be stored. Press the Scan key

twice to clear the error log. Press Pause/Stop to exit Test Mode.

NOTE: A processor upset can cause a bAd#. See H then G.

Error Description

bAd0 Bad checksum. See H then G.

bAd2 Internal RAM error. See H then G.

bAd3 Watchdog timeout. See H then G.

Err1 Belt didn’t start (or no speed sense). See I, E, D, B then A.

Err2 Underspeed (2 mph for 2 seconds without correction in process). See I, E, C then B.

Err3 Speed sense lost. See I, E, A, B and C.

Err5 No 0 switch sense within timed limits. This is declared when the timed

elevation reaches -2% without tripping the index. See F and A.

Err6 Overspeed (1 mph for 1 second or 2 mph for 0.2 seconds without

correction). See I, E.

Err7 EEPROM error (memory lost, loads new defaults, enters Test Mode). See G.

ErrE 0% always on (or switch disconnected or wired backwards). This means

that timed elevation has gone up 2% and the index is still sensed. See F.

SVC Maintenance prompt. Is activated every 9,000 miles (14,484 km). Display shows “SVC”

and beeps every 2 minutes. In Test Mode press “Cool Down” and then press up and

down arrows to display “RST” for reset. Press Enter to reset service odometer to zero.

Action

A Check lower board F Check elevation motor

B Check drive motor G Replace display board

C Check belt and deck H Reset power by unplugging unit for a few seconds,

D Check motor brushes then plug power cord into outlet

E Check speed sensor I Perform speed calibration procedure

Service

Page 4-4

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 69 70

Kommentare zu diesen Handbüchern

Keine Kommentare

CYBEX LCX-425T Wartungshandbuch Seite 34

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Laufbänder CYBEX LCX-425T