CYBEX LCX-425T Wartungshandbuch PDF herunterladen (Seite 63)

Cybex 425T Treadmill Service Manual

Service

Page 4-33

14. Attach the new display cable.

A. Push the new display cable down through the handrail and out the handrail’s bottom

hole.

B. Plug the display cable into the connector plate in the base. See Figure 29.

C. Secure the display cable with wire ties to the handrail.

15. Install the lower handle cover.

A. Using a Philips head screwdriver install the two screws securing the lower handle

cover to the upper handle cover. See Figure 27.

16. Install the accesory tray.

A. Using a Philips head screwdriver install the screw securing the accesory tray to the

lower handle cover. See Figure 26.

17. Install the console back plate.

A. Using a Philips head screwdriver install the ten screws securing the console back from

the upright assembly. See Figure 24.

B. Using a Philips head screwdriver install the two screws that secure the console backin

place. See Figure 25.

18. Connect the cables.

A. Connect these cables into the display board: the display cable (2 connectors), the

contact heart rate cable, the Polar cable and the ground wire. See Figure 25.

19. Check the connections.

A. Check to see that all of the cables are connected firmly in their proper place.

20. Install the console back to the upright assembly.

A. Locate the console back and twelve screws.

B. Place the console back in the correct position on the upright assembly. See Figure 5.

C. Using a Philips head screwdriver install two screws to hold the console back in place.

Do not fully tighten at this time. See Figure 25.

D. Using a Philips head screwdriver secure the console back to the upright assembly

using ten screws. Fully tighten the two screws installed in step 7C. See Figure 24.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 69 70

Keine Kommentare

CYBEX LCX-425T Wartungshandbuch Seite 63