CYBEX LCX-425T Wartungshandbuch PDF herunterladen (Seite 56)

Cybex 425T Treadmill Service Manual

Service

Page 4-26

Elevation Motor

Tools Required

• Phillips head screwdriver

• 9/16” Open end wrench

• 9/16” Socket wrench

! WARNING: Disconnect the power cord before beginning this procedure. Keep wet

items away from inside parts of the treadmill. Electrical shock could occur

even if the treadmill is unplugged.

1. Disconnect the external power source.

A. Unplug the treadmill from the power outlet.

2. Remove the motor cover.

A. Using a Phillips head screwdriver, loosen two screws on each motor cover side (left

and right). See Figure 3.

B. Using a Phillips head screwdriver, loosen two screws on the front motor cover. See

Figure 3.

C. Lift the motor cover up and off the treadmill. The screws will stay in place.

3. Disconnect the elevation motor cable.

A. Cut the wire tie and disconnect the elevation motor cable from the cable connector plate.

4. Remove the elevation motor.

A. Using a 9/16” open end wrench and

a 9/16” socket wrench, remove the

two bolts on the elevation motor (one

at the top and one at the bottom).

NOTE: Hold the motor while you

remove the second bolt so that it

doesn’t fall.

B. Carefully lift and remove the elevation

motor from the treadmill.

5. Calibrate the elevation motor.

A. The switch should be at zero elevation

before adjusting the tube nut. If

necessary connect the elevation

motor, bring the elevation up to 1%

incline and then back down to 0%.

B. Turn the tube with your fingers until

it measures 10.25” (26 cm) from the

center of the top hole to the center of

the bottom hole. See Figure 19.

Figure 19

Bolts

Nuts

10.25”

(26 cm)

Tube

Frame

Elevation

Motor

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 69 70

Kommentare zu diesen Handbüchern

Keine Kommentare

CYBEX LCX-425T Wartungshandbuch Seite 56

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Laufbänder CYBEX LCX-425T