CYBEX LCX-425T Wartungshandbuch PDF herunterladen (Seite 40)

Cybex 425T Treadmill Service Manual

Service

Page 4-10

Front Roller

9. Remove the front roller.

! WARNING: Drive belt is under tension. Do not pinch

fingers while releasing tension.

Tools Required

• 3/4” socket wrench

• 7/16” socket wrench

A. Release drive belt tension by placing a Phillips

head screwdriver into the square hole located in the

bottom of the idler pulley assembly. See Figure 10.

B. While pushing down on the Phillips head screwdriver

carefully slide the drive belt off of the drive motor

pulley. Slowly release tension on the idler pulley

assembly.

C. Using a 9/16” socket wrench loosen the right front

roller bolt. See Figure 11. NOTE: The right bolt will

stay on the front roller. You do not need to remove it

for this procedure.

D. Using a 9/16” socket wrench loosen the left front

roller bolt See Figure 11.

E. Remove the front roller.

10. Remove the running belt.

A. With the front and rear rollers out of the unit you can now remove the running belt.

11. Inspect the rubber mounts.

A. Inspect the rubber mounts under the deck stiffeners for cracks or wear. NOTE:

Unscrew and replace the rubber mounts if the rubber is cracked or worn.

Drive Belt

12. Remove the drive belt.

A. If you are changing the drive belt, slip the drive belt around the flywheel pulley and off

the motor.

13. Install the running belt.

A. Place the running belt in position on the unit. NOTE: It doesn’t matter which way the

running belt goes.

Figure 10

Square

Hole

Idler

Arm

Figure 11

Front

Roller

Bolt

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 69 70

Kommentare zu diesen Handbüchern

Keine Kommentare

CYBEX LCX-425T Wartungshandbuch Seite 40

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Laufbänder CYBEX LCX-425T